Easy DIY Phone Charging Station

Check out what I made today! All you need is an old container. Really, any kind of plastic bottle will work. I chose a detergent bottle because it was the perfect size to hold my phone and cord, and went far enough out so that the charger didn’t get in the way. I think it’s the perfect size for most smart phones.

Peel off the wrapper. It isn’t glued on, so this should take about 2 seconds.

Line your phone up on the back, and lightly mark where the top sits with pencil.

Measure about 2.5 inches above that and mark again. This should be close to the very top. Using this mark as a guide, draw the shape you want it to be. I chose to add a slight dip to the front to make it easier to take my phone in and out. On the back be sure to add enough space for the charger to get through to the outlet.

Use a sharp blade of your choice to carefully pierce the thick plastic. Grab your sharpest scissors and carefully cut along the lines. Repeat to make the outlet hole. This is the hardest part!

Viola! You’re all done. Leave as is, paint it, add stickers, do whatever you want!

Just a note: My phone fits perfectly in this but since I needed to use it to take the picture, you’ll just have to take my word on it. Good luck!

Advertisements

Leave a comment

Filed under Green, Home + Garden, Recycling

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s